Swimming pools need regular inspection and maintenance to keep them looking as good as new. However, while some signs are obvious, others need a closer look. This means that your pool might be calling for a professional resurfacing service or a pool house builder to prevent expensive repairs or replacements down the road. Let’s discuss some common signs you should look out for.
Peeling Or Plaster Flaking
One of the most common signs of pools needing resurfacing is the plaster peeling off. This usually occurs on the floor of your spa or pool. The industry calls it spalling. Spalling mostly occurs due to sustained low calcium or pH levels. You need to keep in mind that for your pool to look brand new, you will need to ensure the chlorine, and pH levels are balanced.
If not, spalling is one of the problems you might come across. In this case, you will not be able to repair the issue. The only way to fix it is by resurfacing or replastering.
Surface stains are yet another common problem calling for pool resurfacing. Surface stains mostly take place due to salt, calcium, and copper. As a result, you will observe that your pool is discolored and will turn into bluish gray color or form crystal deposits. According to industry standards, these are called topical stains.
Therefore, topical stains will stick to the plaster surface much like dirt sticks to the windshield. You can use acid or any other chemical to wash the stains but will have to practice caution. If you find that the pool is severely damaged, you will need to resurface the pool.
Well-maintained pools have a smooth, shiny plaster surface. However, in your case, it might be that the surface has turned all rough since the chemicals have eaten away all the pool surface or have rough calcium deposits. That said, the surface of the pool will feel like sandpaper sooner or later. This could lead to scratches or minor injuries.
Even though you could drain the pool and deep clean it, that will only be a temporary fix. You will need to re-plaster the entire surface to make it look new.
Check cracks are harder to see. However, if you were to come close, you will notice spider web cracks. You will hardly be able to notice them with the water inside the pool but once you drain the pool, you can easily detect them on the surface. Check cracks occur due to the cement in the plaster both contracting and expanding due to temperature changes. Unfortunately, there is no way of getting rid of these cracks. The only way is to resurface or replaster the surface of your pool.
In the beginning, your pool will offer an aesthetic appeal due to the color combination you have opted for but after some time, you will notice that the color has suddenly faded and does not look that impressive now. You will notice that the blue color has white streaks or spots.
This is because the blue color is bleached out, which is mostly found in the footsteps. The discoloration of the plaster is not something you can avoid or stop. It cannot be repaired either. Therefore, this means your pool is calling for resurfacing. You can opt for a more durable pebble finish that will not discolor that easily.
Structural cracks are serious, no matter what the intensity. If you notice that you have to fill the pool almost every other day, it means there is a structural leak somewhere. Although structural repairs do not occur that easily but could take place if the pool has not been maintained in a long time.
Depending on the crack, you may or may not be able to repair or resurface the pool. In some cases, where the cracks are severe, you will need to rebuild the affected portions. Plus, you will need to consult a professional who can offer you the best advice.
In the end, pool surfacing can cost you time, money, and effort. However, you can avoid all that by following a proper maintenance schedule. Plus, always opt for professional pergolas builders long island as you get to keep your pool looking brand new for years to come.
Categories: Home Improvement